Dear Forum Members
On Monday 1st August, Delcam officially joined the worldwide Autodesk family.
Since the Delcam forums were created, we have accumulated over 53,000 posts in 10,000 topics, and now have almost 2,000 registered users like you, providing each other with much appreciated help and advice on a daily basis. We very much want that to continue, and invite you to join us at the new Autodesk forums:
Autodesk FeatureCAM - http://forums.autodesk.com/t5/featurecam-forum/bd-p/276
Autodesk PowerINSPECT - http://forums.autodesk.com/t5/powerinspect-forum/bd-p/278
Autodesk PowerMill - http://forums.autodesk.com/t5/powermill-forum/bd-p/280
Autodesk PowerSHAPE - http://forums.autodesk.com/t5/powershape-forum/bd-p/282
These are all free to join, and signing up will only take a few moments.
The ‘Community FAQ’ http://forums.autodesk.com/t5/community-faq/bd-p/1052
has some useful information to help you setup and manage your forum account. Please spend a few minutes looking through this guide.
From Monday 8th of August the Delcam forums will be put into ‘read-only’ mode, and closed to new users. All of the existing posts will remain, though, as there is a lot of useful knowledge contained in them.
I would like to thank you all for your contribution towards making the Delcam forums such a success over the years, and look forward to continuing to work with you to make the new Autodesk equivalents better than ever.